AVAILABLE ELECTRIC LIFEBOATS
Electric lifeboat refits, built and delivered with care
KMR electric lifeboats are offered either completed or as builds in progress, depending on availability.
Each vessel is stripped back to the original hull and rebuilt with modern electric propulsion, new wiring throughout, and practical finishes designed for daily use on Amsterdam waterways.
Build slots can be reserved while a refit is underway, allowing final specification and handover timing to be agreed in advance.
900+
Hours per hull
48V & 12V
Parallel electrical systems
100%
Electric
Available now
KMR lifeboats ready for sale
Reserve the vessel that matches your mission. Available boats may be completed or offered during an active refit, allowing final specification and handover timing to be agreed on a per-vessel basis.
Standard Inclusions
Every boat includes the full KMR method
Engineering, build quality, and finishing are locked in. Nothing leaves the workshop without meeting these standards.
- 🛠 Hull & structure: full strip to bare GRP and complete hull inspection
- 🛠 Hull & structure: glass-over-ply internal structure, sealed both sides
- 🛠 Hull & structure: fully watertight build spec for 30+ year service life
- ✨ Surface prep & finish: hundreds of hours fairing and sanding for clean, symmetrical lines
- ✨ Surface prep & finish: panels, interiors, and decks finished to custom-built Amsterdam sloop standards for long-term cosmetics
- ⚡ Electrical system: new wiring harness with labeled looms, busbars, and full schematics
- ⚡ Electrical system: marine-grade cable sizing, routing, and protection throughout
- 🔋 Battery & power: batteries integrated inside the console with primary electrics
- 🔋 Battery & power: actively ventilated compartment
- 🔋 Battery & power: battery monitoring system so you always know how much range you have
- 🧭 Console & controls: moulded waterproof KMR console protects all electrics
- 🧭 Console & controls: protected motor controller isolated from moisture and impact
- 🧭 Console & controls: service access without dismantling the boat
- 🌊 Water management: smart bilge and drainage design keeps water away from electrical and propulsion components
- 🌊 Water management: serviceable drainage paths with accessible inspection points
- 🪑 Upholstery & deck use: customisable marine upholstery in selected colours
- 🪑 Upholstery & deck use: cushions designed to remove, store, and lock onboard
- 💡 Lighting: LED navigation lighting and low-draw interior/toilet circuits
- ⚓ Deck hardware: properly positioned cleats with reinforced mounts for daily loads
- 🌬 Ventilation & climate: dry interior airflow for batteries/motors, reduced condensation in storage
Extras & upgrades
Tailor the platform to your mission
Motor upgrade (higher output)
Upgrade from the standard 8.5 kW Green Marine motor to higher-power options matched to hull and use.
Extra battery modules (extended range)
Add 5.1 kWh per module (48 V LiFePO₄) to increase cruising time. Parallel-ready for future expansion.
Extra cushions and upholstery
Additional seating cushions and upholstery tailored to layout and use.
Custom rope fender
Rope fendering sized and finished to protect along working edges.
Victron Cerbo GX monitoring
Central system monitoring with GPS and remote access. Sends alerts for bilge, power, and system faults.
Sound system
Audio system fit to the cabin layout and ambient noise profile.
Additional options and custom equipment can be added on request.
Enquiries & availability
Inquire about the two available hulls, add-ons, or commissioning your own vessel.